Cue touchCUE-V i Manual de usuario descargar pdf (Pagina 9)

5. Setup

5.1. PC Connection

Using LAN Directly to PC

Attach one end of an RJ-45 Ethernet crossed-over cable to the touch panel CUEnet (LAN) port and attach

the other end of the RJ-45 Ethernet cable to your computer.

Ethernet Crossed-Over Cable

This cable can be used to cascade hubs, or for connecting two Ethernet stations back-to-back without a hub.

It works with 10Base-T, 100Base-TX, 100Base-T4 and 1000Base-T. Use a good enough cable, if you are

confused about categories of cables then use Category 5 (enhanced) and you'll be fine even at 1000Base-T.

Top

Front

Top

Front

To Network Interface Card 1 (NIC 1)

Computer

RJ45 Male Connector

To Network Interface Card 2 (NIC 2)

Touch panel

RJ45 Male Connector

Name NIC 1 Color NIC 2 Name

TX+ (BI_DA+) 1 White/Orange 3 RX+ (BI_DB+)

TX- (BI_DA-) 2 Orange 6 RX- (BI_DB-)

RX+ (BI_DB+) 3 White/Green 1 TX+ (BI_DA+)

- (BI_DC+) 4 Blue 7 - (BI_DD+)

- (BI_DC-) 5 White/Blue 8 - (BI_DD-)

RX- (BI_DB-) 6 Green 2 TX- (BI_DA-)

- (BI_DD+) 7 White/Brown 4 - (BI_DC+)

- (BI_DD-) 8 Brown 5 - (BI_DC-)

That means that the White/Orange cable connected to NIC 1 pin 1 should go to NIC 2 pin 3 and NIC 1 pin 2

to NIC 2 pin 6 etc.

Notes

1. 1000Base-T names are in parentheses.

2. It's important that each pair is kept as a pair. TX+ & TX- must be in the pair and RX+ & RX- must

together in another pair. Just as the table above shows.

3. While 10Base-T and 100Base-TX only uses 2 pairs, please connect all four since 100Base-T4 and

1000Base-T needs them and save you some future debugging.

4. The colors originate from the numbering and name on NIC 1.

User Manual touchCUE-V /i

www.cuesystem.com

Page 9 of 27

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 26 27

Sin comentarios

Cue touchCUE-V i Manual de usuario Pagina 9