Cue touchCUE-V i Manual de usuario

CUE, a.s., K Nouzovu 6, 143 00 Praha 4, Czech Republic fax: +420 241 432 446www.cuesystem.commail: [email protected] phone: +420 241 091 240User

5. The connection is based on IEEE Standard 802.3, 2000 Edition. Using LAN Network Attach one end of an RJ-45 Ethernet straight-through cable to the

5. Select Use the following IP address option. Set IP address to 192.168.1.1 (or other address different from 192.168.1.127) and Subnet mask to 255.2

3. Run Cue Director XPL. 4. Open Cue System Workspace (CSW) file with Cue Director XPL. It’s necessary to have appropriated touch panel properly ins

IP settings This page is used for establishing the communication parameters for your touchCUE. The touchCUE uses standard internet protocol (IP) com

boxes. DHCP is not supported in this release. Be sure to click the Apply button for any changes to the DNS to become effective! Date and time page Cur

Internet clock This page is used for synchronization of the touchCUE’s date and time to an internet clock. Begin by selecting the check box for Use

clicking the Upload button. Files are downloaded from the touchCUE-V /i to a personal computer by clicking the File name. Files are easily deleted wit

To create a new folder, enter a name for the new folder, and click the Create button. To upload a file, select the desired file, and click the Upload

Settings – calibration From this page the Calibration procedure can be activated. System page Firmware This page is used for updating the touchCUE

Information The page shows basic information about your touchCUE-V /i’s hardware. The CPU type, CPU frequency, and the Flash and RAM memory sizes,

User Manual touchCUE-V /i UM036_01, 24.4.2008 Copyright © CUE, a.s., Praha, Czech Republic 1990 - 2008. All rights reserved. Specifications are subjec

Backup page The page is used for the backup applications, files and folders. The Backup copies all Applications, Application data and File storage t

Note: For changing your password use the Password menu after you are logged in. Logout page When you are finished working with the touchCUE’s Admi

License page The page shows a software and firmware license. User Manual touchCUE-V /i www.cuesystem.com Page 22 of 27

6. Factory Default Setting Identification Name ... Empty Internet Clock... Empty Date and Time Time zone...

7. Specifications and Mechanical Drawings Display output Resolution 1024 x 768 or 800 x 600 pixels – firmware dependent 65 536 colors (High Color) D

8. Software and Firmware License END-USER NOTICE AND LICENSE AGREEMENT FROM CUE, a.s. NOTICE TO END-USER: CAREFULLY READ THE FOLLOWING LEGAL AGREEM

Notes User Manual touchCUE-V /i www.cuesystem.com Page 26 of 27

User Manual touchCUE-V /i www.cuesystem.com Page 27 of 27 Notes

1. Table of Contents 1. Table of Contents...

2. Introduction 2.1. Overview The touchCUE-V /i touch panel interface allows to turn any plasma monitor, LCD display or video projection system into

3. Box Contents Each touchCUE-V /i comes with • Touch panel interface touchCUE-V /i • Ethernet cable straight-through, Ethernet cable crossed-over

4. Physical Description 4.1. Front Panel of the touchCUE-V /i Indicators ACT activity 100M 100M/10M LAN selection PWR power indication Bu

4.2. Rear Panel of the touchCUE-V /i Power Supply Connector PWR IN This connector allows you to connect touchCUE-V/i to the external power 24V/ 1

Connector pin out Pin1234SignalTX_D1+TX_D1-RX_D2+Description5678RX-D2-GGGroundGroundCat5 Cable ColorWhite / OrangeOrangeWhite / GreenBlueWhite / Blu

5. Setup 5.1. PC Connection Using LAN Directly to PC Attach one end of an RJ-45 Ethernet crossed-over cable to the touch panel CUEnet (LAN) port and