Cue cuenium2 Manual de usuario Pagina 27

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 42
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 26
User Manual
Page 27
www.cuesystem.com
Wired Touch Panels cuenium 2
Ir Capture
All models of cuenium
2
touch panels have possibility to capture IR codes. This is the same functionality as
some ipCUE controllers have. Captured IR codes can be used in all types of controllers too.
Steps are as follows
1. Connect the touch panel to your PC as described in the chapter PC Connection.
2. Arrange IR remoter and touch panel as described below.
IR remoter
3. Start Cue Visual Composer and capture IR codes by standard way.
4. Push Start Capture button in Cue Visual Composer and then press appropriate button on IR remoter.
5. Instructions and messages are displayed on the touch panel and in the Cue Visual Composer.
6. If message “Signal is too weak“ is displayed, change position of IR remoter and try again.
Vista de pagina 26
1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 41 42

Comentarios a estos manuales

Sin comentarios