Cue PEX Manual de usuario

User Manual PEX Software

4. Configuration of the Power Express® modules Double click the module list in the main window to show editable parameters of the module. You can ch

4.1. Configuration of the PER 610 module PER610 is a six-channel relay switching unit for loads up to 10 A per channel. There are all changeable para

− run – a short press switches the relay on for the period of time entered in its parameter. Long time press do the relay on only for button is holdi

4.2. Configuration of one channel dimming modules PED 108, PET 102 and PET 105 PED108 is a one-channel dimmer for resistive and inductive loads up to

• Label - Channel legend which can consist of up to 22 characters. 4.2.2. Direct control of dimmable channels If the On-line box is checked, any

4.3. Configuration of the PED 202 module PED202 is a two-channel dimmer for resistive and inductive loads up to 2.7 A per channel (max. 4 A total).

• Label - Channel legend which can consist of up to 22 characters. 4.3.2. Direct control of dimmable channels If the On-line box is checked, any

4.4. Configuration of the PEA 208 module PEA208 is a two-channel analog output 0 - 10V interface for devices with analog control 0 - 10V (dimmable ba

button makes it stop at the currently reached value. If button down is held, the value does not go all the way to 0%, but stops at 5 %. For a total sw

4.5. Configuration of the PEF 200 module PEF200 is a two-channel interface for fluorescent lamp dimming ballasts with DSI control signal (TRIDONIC, Z

User Manual PEX Software UM031_01, 30.05.2007 Copyright © CUE, a.s., Praha, Czech Republic 1996 - 2007. All r

• Label - Channel legend which can consist of up to 22 characters. 4.5.2. Direct control of dimmable channels If the On-line box is checked, any

4.6. Configuration of the PEF 150 module PEF150 is interface for control up to 64 dimmable ballasts for fluorescent lamps on one bus divided up to 15

button makes it stop at the currently reached value. If button down is held, the value does not go all the way to 0%, but stops at 1 %. For a total sw

Fig. 18 Once you have confirmed by pressing Yes, ally adresses of ballasts are deleted (information about groups remain saved) and a new assigning o

5. Software and Firmware License END-USER NOTICE AND LICENSE AGREEMENT FROM CUE, a.s. NOTICE TO END-USER: CAREFULLY READ THE FOLLOWING LEGAL AGREEM

User Manual PEX Software www.cue.cz Page 25 of 25 Notes

Table of Contents 1. Introduction...

1. Introduction 1.1. Program description... The PEX program is designed for

2. Installation and start of the PEX program 2.1. Program installation... Th

Fig. 2 2.2.2. Program start without modules Power Express ® connected The PEX program can be run without modules Power Express® connected. There i

3. Program operating 3.1. Command menu... Fig. 4 3.2. Selecting com

3.5. Tools menu Alt+T...... LOCATE F3 By this command you can seek a channel

Fig. 9 If there is a conflict in addressing, the warning “CONFLICT“ is shown in the column “Status“ at conflict channels. Double click the right mou